Rod-L M25 Ground Continuity Tester 25 Amps

Description

Standard Description
Description
Rod-L M25 Ground Continuity Tester 25 Amps
OVERVIEW
ROD-L ground bond testers are designed to assess the electrical integrity of the safety ground paths between the exposed conductive surfaces of products and the earth pins of their AC power cords. By using our ground bond testers to continuously test for acceptable resistances in those paths as they are subjected to currents that are near the limit of what the overcurrent protection for their AC power mains will allow, our ground bond testers can test for electrical safety and integrity issues caused by marginal single-strand wiring or other problems that ordinary low current ground continuity testers may miss. Our model M25, M30, M35, and M40 ground bond testers are designed to test for acceptably low resistance at 25 amps, 30 amps, 35 amps, and 40 amps respectively. In addition, our ground bond testers are designed to perform these ground bond tests in compliance with UL, BSI,IEC, and other applicable electrical safety testing standards. These standards serve to help reduce your exposure to product liability claims and your risk of producing electrically unsafe products.
FEATURES
Triggers audible and visual alarms If the ground resistance exceeds the preset value
Performs ground bond tests in full compliance with BSI, VDE, and IEC standards
Test time is adjustable from 1 to 90 seconds
Tests resistance (up to 0.15 Ohms) between the chassis of the tested product and the ground pin of its power cord
Can connect to any ROD-L hipot tester to enable combination testing via a common start-click and tester connection
AC power source supplies 25 Amps (user-specified) at about 2.5 volts
Front panel receptacle is rated to 8000 VAC
Reports test progress, test failures, the chassis ground resistance (0 - 0.15 Ohms), and the applied current
Ground resistance trip point can be preset via a rear-panel potentiometer
Input Power Required: 115/230 VAC, ± 10%, 44-66 Hz, 360 watts maximum
Weight: 30 lbs Net
This ground continuity test instrument can be interconnected to with any Rod-l Test instrument to form an automated test system or used as a stand alone instrument.
Operating and Service Manual available http://www.nousnexus.com/Manuals/ROD-L_M10_M25_M30_M35_Operation_Service.pdf.
The item was tested and working a few years ago. No cables or leads are included. It is being sold for parts or repair because the start switch button is missing and has not been recently tested.
Shipping Weight (lbs.):
36
Shipping Dimensions (in.):
25 x 25 x 13